Tags

, , ,

 

Connect to the top router and enter the telephony service setup wizard.

# conf t
# telephony-service setup
# Set up DHCP?
# Y
#
# IP?
# 10.15.0.0
#
# netmask?
# 255.255.255.0
#
# TFTP?
# 10.15.0.1
#
# Default router?
# 10.15.0.1
#
# start telephony setup?
# Y
#
# Source IP?
# 10.15.0.1
#
# Port?
# default (2000)
#
# phone amount?
# 4
#
# dual lines?
# Y
#
# language?
# english
#
# call progress tone?
# default
#
# DID?
# N
#
# voice msg service?
# N
# 
# call forward timeout?
# 18
#
# change settings?
# no

 

After entering the configuration, plug in the IP phones into the switch port and they should be registered and able to call each other.

Once we got the local pod connectivity up, go throught the wizard for the bottom router with the adequate changes for the ip addresses.

Enter the following commands on the respective routers.

Top# conf t
 Top# dial-peer voice 6 voip
 Top# destination-pattern 50[0,1,2].
 Top# session target ipv4:10.19.0.1
 Top# codec g711ulaw
Btm# conf t
Btm# dial-peer voice 6 voip
Btm# destination-pattern 50[0,1,2].
Btm# session target ipv4:10.19.0.1
Btm# codec g711ulaw

 

We should be able to call across the routers now.

Advertisements